Scotsman CME1356 Manuel télécharger pdf (Page 9)

Bin Control: Installation

The bin control is a thermostat. It must be field

installed after the ice machine has been placed on

the bin.

Before starting, remove the left front panel and any

baffle in the bin.

1. Locate bin thermostat bulb.

2. Route bulb thru routing tube (located between

the compressor and the reservoir).

3. Locate bin thermostat bracket.

4. Carefully position the thermostat bulb on the

bracket (see the diagram on the next page).

5. Fasten the bracket to the bottom of the ice

machine with the two 3-pronged knobs supplied

with the unit.

6. Pull back into the ice machine any excess

capillary tubing.

7. Return the baffle to the bin and continue with

the installation.

Note: If the machine is located at an altitude higher

than 2,000 ft., adjust the thermostat by removing

the plastic cover and rotating the adjustment screw

per the table.

Bin Thermostat Bulb

Thermostat

Bulb

Routing

Tube

Route Bin Thermostat Bulb Into Bin

Bin Thermostat Altitude Correction Table

CW Turns of Range Screw (under plastic cover)

Feet Turns Feet Turns

2000 55

8000 340

4000 160

9000 385

6000 250

10000 405

Use This Table to Adjust Thermostat

Bin

Thermostat

Body

CME1356 and CME1656

May 2000

Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Commentaires sur ces manuels

Pas de commentaire

Scotsman CME1356 Manuel Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Scotsman CME1356