Scotsman CSWE1 Manuel télécharger pdf (Page 12)

Service Diagnosis

Problem Probable Cause Possible Solution

Excessive water dripping on ice Water pan overflowing Check overflow tube for

restrictions. Overflow hose not

inserted in liner drain. Incorrect or

worn flow washer in the inlet

water valve.

Water pan out of position Install correctly

Water inlet tube from water valve

not inserted in water pan.

Locate tube properly.

Ice jam on cutter grid causing

water to flow into bin

Check cutter grid, check for

mineral build up.

Mineral build up on evaporator High mineral content in water Clean the water system

Ice cubes too thin Evaporator thermostat set for thin

cube

Adjust thickness

Non enough water being

circulated over the evaporator

Check for restriction in water lines

Check water pump and distributor

tube

Evaporator thermostat out of

calibration

Re calibrate or replace

Ice cubes too thick Evaporator thermostat set at or

beyond maximum thickness

Adjust thickness

Evaporator thermostat out of

calibration

Re calibrate or replace

Overcharge of refrigerant Recover, evacuate, recharge with

the nameplate charge of R-134a.

Condenser fan does not run Fan blade stuck against

something

Check fan blade

Motor windings open or bearings

seized.

Replace fan motor

Open circuit in wiring Check wiring

Defective evaporator thermostat Replace thermostat

CSWE1

December 1995

Page 12

1 2 ... 7 8 9 10 11 12 13 14 15

Commentaires sur ces manuels

Pas de commentaire

Scotsman CSWE1 Manuel Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Scotsman CSWE1