Scotsman TDE470 Manuel d'utilisateur télécharger pdf (Page 30)

Auger Drive Motor

The windings or top bearing & cover may be

replaced without removing the evaporator or gear

reducer from the machine.

1. Disconnect electrical power.

2. Shut off water supply.

3. Remove top panel.

4. Remove right side panel.

5. Drain the reservoir and evaporator.

6. Disconnect the reservoir outlet tube from the

bottom of the reservoir.

7. Remove screws holding reservoir mounting

bracket to the cabinet.

8. Lift the reservoir up & away from the top of the

auger drive motor.

9. Remove the 4 bolts holding the auger motor

cover to the gear reducer case.

10. Lift the plastic switch housing off the auger

drive motor.

11. Hold the centrifugal switch and remove the

screw holding it to the rotor of the motor.

12. Lift the centrifugal switch up and off the motor.

13. Lift the motor cover up and off the motor.

14. Pull the fan up and off the rotor.

If the windings are to be replaced, remove the left

side panel and control box cover.

1. Locate the auger drive motor wires plugged into

a relay on the circuit board.

2. Disconnect the auger motor’s wires and pull

them back to the auger drive motor.

3. Lift the auger motor windings off the gear

reducer.

If the rotor needs to be removed:

1. Run a screw into the top of the rotor.

2. Grasp the screw with a grip pliers.

3. Pull and/or tap on the pliers to pull the rotor &

bearing out of the gear reducer.

4. Inspect the bearing and input seal. Replace

them if worn.

Note: When the rotor is re-installed, be certain that

the bearing is fully seated in the gear case.

Gear Reducer Rebuild

1. After the gear reducer has been removed, the

internal components may be inspected and/or

replaced. Remove all bolts holding the two case

halves together.

2. Tap against the roll pins at each end of the gear

cases to split them.

3. Pry the case halves apart.

4. Check the internal condition of the gear reducer.

If rusty or water is present, replace the complete

assembly. The oil should be black and the proper

oil level is 1/8" from the top of the biggest gear

(with all gears installed). Check the input seal.

The gears may be replaced individually.

Electrical Shock Hazard

Disconnect electrical

power before beginning.

TDE470

February 1995

Page 30

1 2 ... 25 26 27 28 29 30

Commentaires sur ces manuels

Pas de commentaire

Scotsman TDE470 Manuel d'utilisateur Page 30

Commentaires sur ces manuels