Scotsman FME800R Manuel de service télécharger pdf (Page 20)

CLEANING & SANITIZING

A Scotsman Ice System represents a sizable

investment of time and money in any company’s

business. In order to receive the best return for

that investment, it MUST receive periodic

maintenance.

It is the USER’S RESPONSIBILITY to see that the

unit is properly maintained. It is always preferable,

and less costly in the long run, to avoid possible

down time by keeping it clean; adjusting it as

needed; and by replacing worn parts before they

can cause failure. The following is a list of

recommended maintenance that will help keep the

machine running with a minimum of problems.

Maintenance and Cleaning should be scheduled at

a minimum of twice per year.

Note: Electrical power will be ON when doing in place cleaning.

ICE MAKING SYSTEM: In place cleaning

1. Check and clean any water treatment devices,

if any are installed.

2. Remove screws and the front and top panels.

3. Move the ON-OFF switch to OFF.

4. Remove all the ice from the storage bin.

5. Remove the cover to the water reservoir and

block the float up.

6. Drain the water reservoir and freezer assembly

using the drain tube attached to the freezer water

inlet. Return the drain tube to its normal upright

position and replace the end cap.

7. Prepare the cleaning solution: Mix eight

ounces of Scotsman Ice Machine Cleaner with

three quarts of hot water. The solution should be

between 90 and 115 degrees F.

8. Slowly pour the cleaning solution into the water

reservoir until it is full. Wait 15 minutes, then

switch the master switch to ON.

9. As the ice maker begins to use water from the

reservoir, continue to add more cleaning solution

to maintain a full reservoir.

10. After all of the cleaning solution has been

added to the reservoir, and the reservoir is nearly

empty, switch the master switch to OFF.

11. Repeat step 6 to drain the reservoir. Wash and

rinse the water reservoir.

Sanitizing:

To sanitize, use an approved sanitizing solution or

mix one ounce of household bleach with 2 gallons

of warm (95

F. to 115

F.) water. Repeat steps

8-11 using the sanitizer solution in place of the

cleaning solution.

12. Remove the block from the float in the water

reservoir.

13. Switch the master switch to ON

14. Continue ice making for at least 15 minutes, to

flush out any cleaning solution.

///////////////////////////////CAUTION///////////////////////////////

DO NOT USE any ice produced from the

cleaning solution.

Be sure no ice remains in the bin.

///////////////////////////////////////////////////////////////////////////////

15. Remove all ice from the storage bin.

16. Add warm water to the ice storage bin and

thoroughly wash and rinse all surfaces within the

bin.

17. Sanitize the bin interior with an approved

sanitizer using the directions for that sanitizer.

18. Replace the panels.

Scotsman Ice Machine

Cleaner contains acids.

These compounds may

cause burns.

If swallowed, DO NOT

induce vomiting. Give

large amounts of water

or milk. Call Physician

immediately. In case of

external contact, flush

with water.

KEEP OUT OF THE

REACH OF CHILDREN.

FME800R

June 1994

Page 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Scotsman FME800R Manuel de service Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Scotsman FME800R