Scotsman FME800R Manuel de service télécharger pdf (Page 21)

1. The bin control uses devices that sense light,

therefore they must be kept clean enough so that

they can “see”. At least twice a year, remove the

bin control sensors from the base of the ice chute,

and wipe the inside clean, as illustrated.

2. The ice machine senses water level by a probe

located in the water reservoir. At least twice a

year, the probe should be removed from the

reservoir, and the tip wiped clean of mineral

build-up.

3. The top bearing in the breaker should also be

checked at least two times per year.

Check the breaker bearing by:

••removing the ice chute cover

••

unscrewing the ice sweep

••removing the water shed

••unscrewing the breaker cover (left hand thread)

••

unscrewing the auger stud

Inspect the assembly, looking for wear

4. Clean the remote condenser. Use a vacuum

cleaner or coil cleaner if needed.

Do NOT use a wire brush.

5. Check and tighten all bolts and screws.

MAINTENANCE AND CLEANING

WATER LEVEL

SENSOR

SLIDE UP

TO REMOVE

//////////////////////////////////////

CAUTION: THE TIP

IS MADE OF GLASS

///////////////////////////////////////

RESERVOIR

ICE CHUTE

ICE LEVEL

SENSORS

SLIDE LEFT TO

REMOVE

ICE

SWEEP

BREAKER

COVER

Electrical Shock

Hazard.

Electrical shock can

cause personal injury.

Disconnect electrical

power before beginning.

FME800R

August 1993

Page 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Scotsman FME800R Manuel de service Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Scotsman FME800R