Scotsman FME800R Manuel de service télécharger pdf (Page 28)

WATER RESERVOIR

1. Shut off the water supply to the icemaker.

2. Remove front panel and reservoir cover.

3. To remove float only, disconnect water inlet

compression fitting at reservoir inlet, push in on

locking tab, pull float up and out of the reservoir.

Note: there is a separate plunger/seat inside the

valve assembly that may be replaced.

4. To remove reservoir, disconnect water outlet at

reservoir base.

5. Remove drain hose from reservoir.

6. Remove water level sensor from reservoir.

7. Remove mounting screws from reservoir

bracket, and remove reservoir from icemaker.

8. Reverse to reassemble.

BIN CONTROLS (Ice Level Sensors)

1. Disconnect electrical power.

2. Remove front panel.

3. Remove control box cover.

4. Locate ice chute, at the base of the chute, in

front of and behind it are two plastic bin control

mounts.

5. Slide each bin control to the left, and in the

control box, disconnect the electrical leads

connecting the bin control to the circuit board.

6. Reverse to reassemble, be certain that the bin

controls are aligned so that the ice level sensors

are visible (centered) through the holes in the ice

chute.

FLOAT

ASSEMBLY

Valve

Seat/Plunger

LOCKING TAB

ICE

CHUTE

SLIDE BIN

CONTROLS IN

AND OUT

REMOVAL AND REPLACEMENT: Water Reservoir & Bin Controls

FME800R

June 1994

Page 28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

Scotsman FME800R Manuel de service Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Les fabricants de glaçons Scotsman FME800R